![]() This sensor uses a resistive-type humidity measurement component and an NTC temperature measurement component which are connected to an integrated 8-bit microcontroller. The DHT11 is a device used to measure temperature and relative humidity. Interfacing STM32 Blue Pill with 1602 LCD To see how to interface STM32 Blue Pill board with 16×2 LCD go to the the following post: The STM32 Blue Pill board MCU reads temperature (in ☌) & humidity (in rH%) values from the DHT11 sensor and print their values on 16×2 LCD display. ![]() We will also see the simulation of the STM32F103C8T6 Blue Pill board with the DHT11 sensor using Proteus simulation software. ![]() This post shows how to interface STMicroelectronics ARM Cortex-M3 microcontroller based STM32F103C8T6 Blue Pill development board with DHT11 digital temperature & humidity sensor where Arduino IDE software is used to write the interfacing program. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |